Do not route the Mackie input to B.Ĭonnect your Mainboard audio output to a stereo line in on the Mackie e.g. Route all inputs to send to your caller to Bus B. Go to vMix settings -> Audio Outputs and set Bus B to your Mainboard audio. If you really want to use your Bluetooth interface: ![]() Now it should all work without having loops and echo. Take care what inputs you want to be always active or auto mixed: Set the PC audio volume with the "USB Input Level" knob on the Mackie. This is the audio from the DJ software.īe sure that the "USB Thru" button on the Mackie is not pressed/engaged. Be sure that this is not routed to bus A.Īny other vMix input with audio (videos.) should be routed to M and A.Īdd an audio input and choose 'CABLE Output (VB-Audio Virtual Cable)'. Set the audio output for Bus A to the Mackie (Bus B = none).Īdd an audio input for your Mackie. You're using the headphones connected to the Mackie. Set the audio output for Headphones to none. This will be the bus for streaming and recording and doesn't need to be routed to hardware. In vMix set the audio output for the Master to none. Reboot, open the DJ software and go to Preferences -> Sound Hardware -> Output and set the Master to 'CABLE Input (VB-Audio Virtual Cable)' ![]() Unzip it to a folder and open the VBCABLE_Setup_圆4.exe with admin rights. To get the audio output from your DJ software into vMix you need a virtual audio cable. For other routings including audio hardware outputs I use bus A and B. I prefer to use the Master audio bus just for recording and streaming. There's only one way to make this work without getting a loop somewhere in the chain. ![]() You should really consider to use vMix Call for that. Integrating this Bluetooth interface into your workflow will be a real challenge with the equipment you have.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |